Basic Operations; Sending A Fax; Basic Procedure For Sending Faxes - Sharp AR-M237 Copier Manual

Chapter 2
2

BASIC OPERATIONS

This chapter explains the basic procedures for sending and receiving faxes.

SENDING A FAX

BASIC PROCEDURE FOR SENDING FAXES

The procedure for sending a fax in memory transmission mode (p.14) is explained in the following.
1
Make sure that the machine is in fax
mode.
SCAN
FAX
JOB STATUS
2
Make sure that memory transmission
mode is selected.
SUB ADDRESS
SPECIAL MODES ADDRESS REVIEW
DIRECT TX MEMORY TX
3
Place the original.
You cannot place originals in both the RSPF
Note
and on the document glass and send them
in a single fax transmission.
12
When the [FAX] key light
DATA
is on, the machine is in
fax mode. If the light is
LINE
not on, press the [FAX]
DATA
key.
CUSTOM SE
Memory transmission
mode is selected when
"MEMORY TX" is
highlighted in the
[DIRECT TX MEMORY
TX] key. If "DIRECT TX "
is highlighted, touch the
[DIRECT TX MEMORY
TX] key.
For originals that can be
sent, see "ORIGINALS"
on page 9.
If you are sending
multiple pages, scan the
pages in order beginning
from the first page.
4
Check the original size.
EXPOSURE
STANDARD
RESOLUTION
AUTO 8½x11R
ORIGINAL
original or the original size was not correctly detected,
touch the [ORIGINAL] key and set the original size.
("MANUALLY SETTING THE SCANNING SIZE"
(p.20))
5
If needed, adjust the resolution and
exposure settings.
AUTO
EXPOSURE
STANDARD
RESOLUTION
AUTO 8½x11R
ORIGINAL
6
Enter the fax number.
ACC.#-C
REDIAL key (p.11) or an auto-dial number (p.11).
If the address directory
screen appears, touch
the [CONDITION
SETTINGS] key to
display the condition
settings screen (p.7).
If you loaded a
non-standard size
Resolution: Page 21
Exposure: Page 22
If needed, select the
sender's name. (p.45)
The number that you
entered appears in the
message display
("Condition Setting
screen" (p.7 )).
1
If it is not correct, press
the [CLEAR] key ( )
and re-enter the number.
You can also use the