Storing Relay Groups - Sharp AR-M237 Copier Manual

STORING RELAY GROUPS

Use this procedure to store a relay group (relay machine and end receiving machines) for a relay request
transmission (p.50). Up to 10 relay groups can be stored.
One relay machine is stored per group. The relay machine is specified by entering the fax number with the numeric
keys.
Each end receiving machine is specified by entering the full fax number with the numeric keys, or by specifying a
rapid number, speed dial number, or group number stored in the relay machine.
To store a relay group, follow steps 1 to 4 on pages 65 to 66 (touch the [RELAY GROUP] key in step 4), and then
follow the steps below.
1
Touch the [GROUP NAME] key.
GROUP NAME
RELAY STATION
RECIPIENT
See page 80 for the procedure for entering letters.
2
Touch the [RELAY STATION] key.
GROUP NAME SHARP CORPO
RELAY STATION
RECIPIENT
3
Press the numeric keys to enter the
fax number of the relay machine.
DIRECT ADDRESS / RELAY GROUP
01
RELAY STATION
ENTER THE RELAY STATION FAX No. VIA THE 10-KEY PAD, THEN PRESS [OK].
• To insert a pause between digits of the number,
touch the [PAUSE] key. The pause appears as a
hyphen "-". See page 97 to set the duration of the
pause.
• If you make a mistake, press the [CLEAR] key (
to clear one digit at a time, and then enter the correct
digit(s).
The "No." that
automatically appears is
the lowest number from
01 to 10 that has not yet
been programmed.
When the [GROUP
NAME] key is touched,
the letter-entry screen
appears. Enter up to 36
characters for the name.
The number entry screen
for the relay machine
appears.
NEXT EXIT
CANCEL OK
PAUSE
)
4
Touch the [OK] key.
You will return to the relay group storing screen.
5
Touch the [RECIPIENT] key.
GROUP NAME SHARP CORPO
0666211221
RELAY STATION
RECIPIENT
PROGRAMMING
The screen for entering
the numbers of the end
receiving machines
appears.
75
6