Sharp AR-M237 Copier Manual page 108

11
When the interface selection screen
appears, select "Parallel" and click the
"Next" button.
12
Select the printer port and click the
"Next" button.
Select "LPT1" for the printer port.
If "LPT1" does not appear, another printer
Note
or peripheral device is using LPT1. In this
case continue the installation, and after the
installation is finished, change the port
setting so that the machine can use LPT1.
This procedure is explained in "Another
printer is using the parallel port (when
using a parallel cable)" on page 14.
13
When the model selection window
appears, select model name of your
machine and click the "Next" button.
For the model name of your machine, see
"PART NAMES AND FUNCTIONS" in the
operation manual for copier.
14
Click the "Yes" button.
INSTALLING THE SOFTWARE
15
When "The installation of the SHARP
software is complete" appears, click
the "OK" button.
16
Begin the installation of the PC-FAX driver
(if "PC-FAX Driver" was selected in Step 7).
Follow the on-screen instructions.
• When the model selection window appears,
select model name of your machine.
• During installation of the PC-FAX driver,
you will be asked to select the port. If
you are using the parallel port, select
"LPT1" and continue the installation.
Click the "Finish" button when the message
informs you that setup is successful.
17
When the "Finish" screen appears,
click the "Close" button.
When "After Windows system restarts,
connect the interface cable to the PC"
appears, click the "OK" button.
After the installation, a message
Note
prompting you to restart your computer
may appear. In this case, click the "Yes"
button to restart your computer.
18
Turn off the power of the machine and
your computer, and connect the
machine to your computer with the
parallel cable. (p. 10)
After connecting the machine to your
computer, turn on the power of the
machine and then start up your computer.
This completes the installation of the software.
• If you installed the printer driver, configure the
printer driver settings as explained in
"CONFIGURING THE PRINTER DRIVER" (p. 11).
9