Transmission Problems - Sharp AR-M237 Copier Manual

TROUBLESHOOTING
FAX PROBLEMS
Problems that are related to the fax function are explained in the following.
For paper misfeeds, see "MISFEED REMOVAL" in the operation manual for copier. For general machine problems,
copier problems, printer problems, and network scanner problems, see the corresponding manual for the function.
The machine does not operate correctly
Problem
The machine does not
operate.

Transmission problems

Problem
Dialing is not possible.
Transmission is not
possible.
The transmitted image prints
out blank at the receiving
side.
The transmitted image is
distorted.
Transmission does not take
place at the specified time.
White or black lines appear
in the transmitted image.
88
Cause and solution
The power switch is turned off.
→ Turn on the power switch.
Cause and solution
The correct dial mode is not set for your line.
→ Check your line and set the correct dial mode.
The telephone line is not connected.
→ Check the connections.
The power switch is turned off.
→ Turn on the power switch.
The machine is not in fax mode.
→ Press the [FAX] key to set the machine to fax mode.
The receiving fax machine does not have paper.
→ Check with the operator of the receiving machine.
The sub-address or passcode is not correct.
→ Check with the operator of the receiving machine.
The receiving machine is using the line.
→ Check with the operator of the receiving machine.
The size of the original was not correctly detected.
→ Check the original size.
The original was placed so that the wrong side was
scanned.
→ Make sure the original is placed so that the correct side is
scanned.
The receiving machine is using thermal paper and
the thermal paper was loaded with the wrong side
facing out.
→ Check with the operator of the other machine.
The line conditions were poor due to thunder or
other reason.
→ Try the transmission again.
The resolution and exposure settings were not
suitable.
→ Check the resolution and exposure settings.
The machine's clock is not set to the correct time.
→ Set the clock to the correct time.
The document glass is dirty.
→ Clean the document glass.
Page
3
Page
-
3
3
12
-
10
-
-
21
operation manual for
copier
operation manual for
copier