Uploading Html Files - Extron electronics DXP DVI Pro User Manual

Uploading HTML Files

You can create customized HTML pages for the DXP to display. The HTML Files List
window (shown below) provides a way to view the contents of the DXP file system and to
upload custom HTML pages to the switcher.
Figure 84.
NOTES:
• The file listed in figure 84 is shown for example only and may not be present on
your switcher.
• The HTML Files List window is for inserting your own HTML pages. This is not
the window used to replace the firmware that controls all switcher operation. See
Updating the Firmware
• The following characters are invalid or not recommended in file names:
+ ~ , @ = ` [ ] { } < > ' ' " " ; : | \ ? and {space}.
Upload HTML pages as follows:
1. Connect the PC to the DXP via the rear panel Remote RS232/RS422 port, the front
panel Config port, or the Ethernet port.
2.
Start the Matrix Switcher Control Program and connect to the DXP switcher (see steps
1 through 4 under
procedure).
3. From the Tools menu, select HTML File Manager. The HTML Files List window
opens.
4. Click the Pick File(s)to Load to Server button. The Select Files to
Upload to Extron Server window opens.
5. Navigate to the folder where you saved the HTML files and select them.
NOTES:
•
•
6. Click the Open button. The file uploading process may take a few minutes.
7. Click the Update button to confirm the upload.
8. Click the Close button to exit the HTML Files List window.
HTML Files List Window
on page 88 to update the firmware.
Downloading and Installing the Software
To select multiple files, hold the <Ctrl> key while you click on the desired files.
If you want one of the HTML files that you created to be the default start-up
page, name the file "index.html." The DXP switcher looks for that file name
when you first connect to it using an Internet browser.
DXP DVI Pro and DXP HDMI Series • Matrix Software
on page 74 for the
90