Extron electronics DXP DVI Pro User Manual page 93

Setting the local time
The Time (local) field displays the current time in the local time zone. If necessary, click
the Sync Time to PC button to set the switcher to the internal time on your computer, or
adjust the time manually as follows:
1. Click in the Time (local) field. A time editing field appears with the date in the format
( :( :( (00:00:00 to 23:59:59). The graphic cursor becomes a text cursor in
H)H M)M S)S
the time editing field.
2.
Edit the field as desired to set the proper time. Remember to use 24-hour time. Leading
zeros are optional.
3. Press the <Tab> key or click in another field to exit the Time field.
4. Click the Take button for the time change to take effect.
Sync Time to PC button
Clicking the Sync Time to PC button causes the computer you are operating to send its
internal time to the switcher in a set time command.
Setting the offset from GMT
The GMT field displays the amount of hours and minutes that the local time varies from the
GMT international time reference. If necessary, adjust the offset as follows:
1. Click in the GMT field. An offset editing field appears with the offset in the format
± : (–12:00 to +14:00). The graphic cursor becomes a text cursor in the set
HH MM
offset field.
2. Edit the field as desired to set the proper offset. Leading zeros are optional. Some time
zones are on the half-hour (30 minutes).
3. Press the <Tab> key or click in another field to exit the set offset field.
4. Click the Take button for the offset change to take effect.
Enabling daylight savings time
When daylight savings time is enabled, the switcher updates its internal clock between
daylight savings time and standard time in the spring and fall on the date that the time
change occurs in your location. When daylight savings time is turned off, the switcher does
not adjust its time reference.
Select the Use Daylight Savings checkbox to enable daylight savings time.
Setting the administrator password
The Administrator Password field displays the password required to log on to the
DXP switcher via the Ethernet port with all administrator rights and privileges. Passwords are
case-sensitive and are limited to 12 uppercase and lowercase alphanumeric characters.
While you are logged on as a user, this field is masked with asterisks (************) as a
security measure.
NOTES:
• The following characters are invalid or not recommended in passwords:
+ ~ , @ = ` [ ] { } < > ' ' " " ; : | \ ? and
• Editing the Administrator Password field while connected via Ethernet can
immediately disconnect your computer from the DXP. It is recommended that you
connect via RS-232 or RS-422 to edit this field.
DXP DVI Pro and DXP HDMI Series • Matrix Software
space .
{ }
85