Extron electronics DXP DVI Pro User Manual page 85

2. Choose the communication port through which the DXP is connected to the computer:
If you selected a Comm port, check the baud rate displayed in the Comm Port
•
Selection window. To change the baud rate, click the Baud button to display the
baud rate pop-up list. (After you click it, this button changes to OK.) Double-click
on the desired baud rate (available rates are 9600, 19200, 38400, and 115200. The
default is 9600). Click OK and proceed to step 4.
Figure 73. Baud Rate Pop-up List
If you selected IP [LAN], click OK and proceed to step 3.
•
If you selected Emulate, click OK and see
•
page 101.
3. If you selected IP [LAN] in step 2, the IP Connection window opens.
Figure 74. Address and Password Entry for IP Connection
a.
Check the Extron IP Address field in the IP Connection window. The field
displays the last IP address entered for an Extron product.
If the IP address is correct: Proceed to step 3b.
If the address is not correct: Either click in the Matrix IP Address field and
enter the IP address or click on the scroll down button ( ) and select from among
the recently used addresses.
NOTE: If your local system administrators have not changed the value, the
factory-specified default address, 192.168.254.254, is the correct value
for this field.
b. If the DXP is password protected, click in the Password field and enter the
appropriate administrator or user password.
Using Emulation Mode
DXP DVI Pro and DXP HDMI Series • Matrix Software
on
77