Extron electronics DXP DVI Pro User Manual page 43

NOTES:
• I/O groups are protected when front panel lock mode 2 is selected. You can
view the groups in lock mode 2, but you cannot change them from the front
Locking and Unlocking the Front Panel (Executive Modes)
panel (see
page 38).
• If front panel lock mode 2 is selected and you try to perform this step, the
button presses are ignored and the Enter, Video, and Audio buttons blink.
5. Press and release the Preset button to select group 2.
Press and release the Preset button to select group 2.
The button lights to indicate the selection.
C O N T R O L
VIEW
ENTER PRESET
Group # 1 2 3
Figure 50. Select I/O Group 2
6.
Press and release the desired input and output buttons.
Press and release the Input 5 through Input 8 buttons.
The selected buttons light.
INPUTS
1 2 3 4 5
Press and release the Output 5 through Output 8 buttons.
The selected buttons light.
1 2 3 4 5
OUTPUTS
Figure 51. Assign Inputs and Outputs to Group 2
7. Simultaneously press and release the Video and Audio buttons to exit I/O group
mode.
I / O
VIDEO AUDIO
Press and release both buttons.
Figure 52. Deselect I/O Group Mode
NOTE:
If you do not press any front panel buttons for approximately 30 seconds,
the front panel times out and the switcher exits I/O group mode.
Group 1 consists of inputs and outputs 1 through 4.
•
Group 2 consists of inputs and outputs 5 through 8.
•
Outputs 1, 3, 4, and 8 remain tied to input 5, because those ties were created
•
before the groups were formed (examples 1 through 4).
ESC
4
6 7 8
6 7 8
DXP DVI Pro and DXP HDMI Series • Operation
on
35