Extron electronics DXP DVI Pro User Manual page 50

The table below provides a summary of the reset modes .
Mode Activation
1
Hold in the Reset button while
applying power to the switcher.
3
Hold in the Reset button until
the Reset LED blinks once (after
approximately 3 seconds); then within
1 second press Reset momentarily
(for less than 1 second) .
4
Hold in the Reset button until
the Reset LED blinks twice (once
after approximately 3 seconds and
again after 6 seconds); then within
1 second press Reset momentarily
(for less than 1 second).
5
Hold in the Reset button until the
Reset LED blinks three times (once
after approximately 3 seconds, again
after 6 seconds, and then again after
9 seconds); then within 1 second
press Reset momentarily (for less
than 1 second).
NOTE: Mode 5 reset clears most adjustments. To save these settings, use the Matrix Switchers
Control Program and select Save MATRIX settings as... from the File menu before you
perform this reset (see the Matrix Switcher Control Program help file for more information).
Reset Modes Summary
Result
Restores the factory-installed firmware. It
does not clear the current configuration.
Turns events on and off. During resetting,
the Reset LED blinks two times if events
are starting or three times if events are
stopping.
•
Enables ARP capability.
•
Sets the IP address, subnet address, and
gateway address to the factory defaults.
•
Sets port mapping to the factory default.
•
Turns DHCP off.
•
Turn events off.
The Reset LED blinks four times in quick
succession during the reset.
Performs a complete reset to factory
defaults (with the exception of the
firmware), which includes:
• E verything mode 4 does
•
Reset of almost all real time adjustments:
Clears all ties, presets, audio or
•
RS-232 mutes, and I/O grouping.
• Resets all IP options.
Remov es or clears all switcher files.
•
The reset LED blinks four times in quick
succession during the reset.
DXP DVI Pro and DXP HDMI Series • Operation
Purpose/Notes
Mode 1 can be
used to remove a
version of firmware if
incompatibility issues
arise.
Mode 3 is useful for
troubleshooting.
Mode 4 enables you
to set IP address
information using
ARP and the MAC
address.
It does not replace
any user-installed
firmware.
Mode 5 is useful if
you want to start over
with configuration and
uploading and also to
replace events.
42