5-28
Installation - Control Module
SD CARD INSTALLATION
SD cards provide a means of updating product firmware, drive cloning and application backup and recovery.
Parker recommended SD cards are listed in the 'Chapter 7: Associated Equipment – Control Module' section.
To fit the cards:
1. Remove the GKP/Blanking Plate (if fitted) as instructed on page 5-3.
2. With the SD card pointing label side down, insert the card into the slot in the control module top moulding. The card should 'click'
when engaged.
To remove the SD card:
1. Push the SD card down so that it 'clicks'.
2. It should now pop out from the slot, ready for removal.
AC30 series Variable Speed Inverter