Setup Wizard - Parker AC30P Hardware Installation Manual

9-6
The Graphical Keypad

Setup Wizard

The purpose of the Setup Wizard is to configure the inverter in a clear and concise manner.
Starting the Setup Wizard
The Setup Wizard is automatically invoked when the inverter is reset to factory default settings.
Alternatively, the Setup Wizard may be invoked at any other time by navigating to the 'Welcome Screen' at the top of the menu tree and pressing
Soft Key 1, as shown by the Setup Wizard
Note: It is always recommended that the Setup Wizard is completed once started. Do not interrupt the power when the Wizard is in
progress.
Navigating the Setup Wizard
At each step of the Setup Wizard, pressing the OK key selects the displayed value and also moves on to the next step.
Pressing Soft Key 1 moves back a step.
Pressing the UP and DOWN keys modifies the parameter value.
Note: Accepting each choice without change by pressing OK will result in no change to the inverter's configuration.
Setup Wizard Stages
The Setup Wizard starts by asking what user view level is required for the GKP, followed by a list of languages for which the user selects their
preference.
The user will then be asked if they would like to continue and run the Wizard. If 'yes', the first option is to "Set Factory Defaults". Changing this
parameter to TRUE then pressing OK resets all parameters back to the default value determined by the inverters hardware configuration. In most
case, this is recommended. If this choice is left FALSE the setup wizard starts with all parameters with their previously set values.
The rest of the Setup Wizard consists of several sections, each of which corresponds to a functional component of the inverter, for example:
- Application selection
- IO Option, (includes the Encoder)
- Analog input and output ranges.
- Motor Data
If not required, any section may be skipped.
The default setting for all parameters depends on earlier answers and on the physical configuration of the inverter. All data entered is
automatically saved without the need for any additional commands.
Finalising Setup
Once the Setup Wizard has been run to completion, the feature is automatically disabled. Power cycling to the inverter will not cause the Setup
Wizard to be run again, though If this is required, this can be achieved as detailed above in 'Starting the Setup Wizard'.
Note: For more detailed explanations and information about drive operation and functionality, refer to 'HA503711U003 – AC30 Series
Software Reference Manual'.
AC30 series Variable Speed Inverter
indicator.
- Motor Control
- Fieldbus options
- On-board Ethernet
- Auto tune