Fitting A Remote Gkp - Parker AC30P Hardware Installation Manual

Fitting a Remote GKP

It is possible to order an AC30 control module with either the Graphical Keypad (GKP) mounted on the front of the unit, or with a blanking plate
fitted in its place.
Where a control module is not fitted with a GKP, one can be ordered separately through your local sales office.
Refer to 'Chapter 7: Associated Equipment – Control Module' for options.
When remote mounting the GKP to either a cubicle door or panel, it must be fitted onto a flat surface.
The cut-out details for doing so are given below:
GKP (Reverse side)
- The yellow dotted line is the cutout detail to
allow remote fitting of the connection lead.
- 4x GKP fixings are M3 x 10 self tapping
screws.
- Connection lead is a RS232/REM OP STA
with a Steward 28A2025-OAO connector.
Note: The 3 m connection lead supplied by Parker is the maximum length that can be used.
AC30 series Variable Speed Inverter
Gasket
Reverse side of the
GKP
All measurements in millimeter.
Installation - Control Module
5-29