Radiated & Conducted Emissions - Compliance Overview - Parker AC30P Hardware Installation Manual

RADIATED & CONDUCTED EMISSIONS - COMPLIANCE OVERVIEW
Standard EN 61800-3
Radiated Emissions
Category C1
Category C2
Category C3
Conducted Emissions
Category C1
Category C2
710
Stacks
Category C3
Where I>=100A
740
Category C3
Stacks
Conducted emissions solution true for default, 2kHz switching frequency. Operation at higher switching frequencies will require extra filtering.
The drive is suitable for use on both IT and TN supplies when fitted with either the internal filter, or a suitably specified external EMC
For example, if an inverter fitted with an internal C2 filter is on an IT supply, it will now only comply with the higher C3 limits.
Refer to 'Chapter 4: Installation – Power Stack' for details on how to remove the Y-cap and VDR disconnects when installing the
Where a solution is required that is not met by the AC30 product range offering, the internal C3 filter emissions' plots have been provided to allow
specialist EMC filter design companies to tailor a design to meet the customer's needs.
AC30 series Variable Speed Inverter
Frame K
When mounted inside a cubicle with the required attenuation between:
710-4Kxxxx-xE... 710-4Lxxxx-xE...
product codes.
Maximum motor cable Maximum motor cable
length 50m.
740-4xxxxx-xN... product codes, when supplied by an AC to DC full bridge and required line choke.
WARNING
filter. However, when used on an IT supply, the filter effectivity is reduced.
product on an IT supply.
Frame L Frame M
n / a
30-1000MHz @ 10dB
No specific enclosure required
External EMC filter required.
See page A-8 for inverter emission plots.
External EMC filter required.
See page A-8 for inverter emission plots.
710-4Mxxxx-xE...
product codes. product codes.
Maximum motor cable
length 50m. length 50m.
Maximum motor cable length 50m.
A-7
Compliance
Frame N
710-4Nxxxx-xE...
product codes.
Maximum motor cable
length 50m.