European Compliance; Ce Marking - Parker AC30P Hardware Installation Manual

A-2
Compliance

EUROPEAN COMPLIANCE

CE MARKING

Low Voltage Directive
The CE marking is placed upon the product by Parker Hannifin Manufacturing Ltd to facilitate its free movement within
the European Economic Area (EEA). The CE marking provides a presumption of conformity to all applicable directives.
Harmonized standards are used to demonstrate compliance with the essential requirements laid down in those relevant
directives.
It must be remembered that there is no guarantee that combinations of compliant components will result in a compliant
system. This means that compliance to harmonised standards will have to be demonstrated for the system as a whole
to ensure compliance with the directive.
Local wiring regulations always take precedence.
Where there are any conflicts between regulatory standards for example earthing requirements for
electromagnetic compatibility, safety shall always take precedence.
When installed in accordance with this manual the product will comply with the low voltage directive 2014/35/EU.
Protective Earth (PE) Connections
Only one protective earth conductor is permitted at each protective earth terminal contacting point.
Unless local wiring states otherwise, the minimum PE earth conductor should be as follows:
Cross-sectional area of phase
conductors 'S' (mm²)
Values in table assume PE conductor is the same material as the phase conductors.
In addition to the values in this table, the protective earth conductor cross section area must be at least 10mm² (copper
Cu conductor).
Minimum cross-sectional area of
PE conductor 'S
S ≤ 16
16 < S ≤ 35
35 < S
' (mm²)
P
S
16
S / 2
AC30 series Variable Speed Inverter