4-12
Installation - Power Stack
FRONT PANEL REMOVAL
The front panel of the inverter will need to be removed in order to access the fan voltage selection PCB. The installer should check that the fan is
set to operate on the correct supply voltage.
Removal of this panel also allows access to the AC line filter PCB, and in particular the Y-cap and VDR disconnects.
Note: It may be necessary to remove the AC30 control module prior to removal of the inverter front panel. See 'Chapter 5: Installation –
Control Module'.
Unscrew the 4x fixings to
remove the front panel.
AC30 series Variable Speed Inverter