Chapter 2: Introduction; About This Manual - Parker AC30P Hardware Installation Manual

Introduction
Chapter 2:

About this Manual

Who is this Manual aimed at?
This Manual is intended for use by the installer of the AC30 series inverters. It assumes a reasonable level of understanding in this discipline.
It is more detailed than the relevant QuickStart manual.
There is a separate software reference - HA503711U003 'AC30 Series Software Reference Manual' that is intended for use by the user and
programmer of the AC30 series inverters.
Note: It is important to always pass on this Manual to any new user of the AC30 series inverter.
How the Manual is Organised?
This Hardware Installation Manual is organised into chapters, indicated by the numbering on the edge of each page. If the manual is to be printed
it is designed so that it should be printed double-sided using the short-edge for binding.
Information for the following AC30 units is included - Frame K, L, M & N power stacks, and AC30V, AC30P & AC30D control modules which, are
collectively referred to as "the Inverter" or "drive" throughout the manual.
Product coding: Any "x" within a product code indicates there are variants, see the 'Appendix D: AC30 Series Product Codes' section for more
information.
AC30P
Any text placed in a highlighted area as this sample shows, only refers to the AC30P and AC30D control modules.
AC30D
Parker Hannifin Manufacturing Limited is referred to as "Parker" throughout the manual.
Please read all Safety information before proceeding with the installation and operation of this unit.
AC30 series Variable Speed Inverter
IMPORTANT
2-1
Introduction