Table of Contents
Advertisement
3-43
3
4
4
7
1
2
5
5
6
7
– Take down the motorcycle with the help of a second person and take
the assembly stand
out of the footrest holder.
1
– Jack up the motorcycle on the link fork.
– Mount the footrests on both sides.
– Position the foot brake pedal and tighten the screw
(+ Loctite 243).
– Attach the return spring to the foot brake pedal.
– Mount the retaining pin
3
– Position the rear exhaust manifold and fix it with the nuts
not tighten the nuts yet.
– Position the front exhaust manifold and fix it to the holder with the
screw
.
6
– Tighten the nuts
of the front exhaust manifold and the nuts of the
5
rear exhaust manifold.
NOTE:
– in each case, one of the studs must be mounted with a sleeve that
acts as a spacer between the cylinder and the clamping plate.
– the exhaust nuts should be tightened evenly without warping the
clamping plate.
– Tighten the exhaust clamps of the front and rear exhaust manifolds.
– Tighten the screw
of the holder of the front exhaust manifold.
6
– Route the lines of the lambda probe, secure them with cable binders
and create the plug-in connections
2
by installing the lock on retaining pin.
.
7
with 25 Nm
, but do
4
Advertisement
Table of Contents
Troubleshooting
