KTM 990 Adventure Repair Manual page 51

2
1
4
6 7
9
bm
bl
– Insert the locking pin in the pushrod.
– Mount the adapter for the hydraulic clutch
– Mount the chain securing guide
slave cylinder
3
– Screw on the clutch slave cylinder
5
– Position the side stand.
– Tighten the two bolts
243).
– Mount the side stand switch
clips.
8
– Mount the oil tank and tighten the fixing bolts
– Connect the return line
loaded band-type clamp with the special pliers 600.29.057.100.
– Attach the oil lines from the oil tank to the valve covers
pliers 600.29.057.100).
– Mount the oil line onto the oil tank
screws and tighten with 10 Nm.
NOTE:
– to allow the oil pump to build up the oil pressure faster, remove the
suction line (left) from the oil tank and fill with engine oil.
– Check the hose part of the suction line for cracks.
bk
9
and the adapter for the clutch
2
.
3
and the chainguard
4
and the nut
6 7
and fasten the cable with the cable
8
to the oil tank and mount the spring-
bk
with a new O-ring, mount the
bm
3-20
.
1
.
5
to 45 Nm (with Loctite
.
9
(special
bl