Table of Contents
Advertisement
1
1
5
4
6 3
7 6
bl
bm
– Screw on the radiator together with the fan and the radiator shield
1
– Connect
600.29.057.100)
– Create the electrical plug-in connection of the horn, fan motor and
temperature switch
2
– Mount the lower air filter box on the intake
R
EMOVE THE CLOTH USED TO COVER THE INTAKE PORTS
– Place the throttle body into the lower section of the air filter box.
NOTE: The lower section of the air filter box must be raised slightly to
make room for the plug-in connection 3 of the throttle body.
– Connect the drain hose to the lower section of the air filter box.
– Connect the lower section of the air filter box to the intake flange.
– Attach the sleeves of the throttle body to the intake flange.
NOTE: the clamps on the carburetor connection boots must be aligned
so that they can be tightened through the openings in the side covers.
– Insert the throttle body in the bellows and tighten the bellows
clamps
– Connect the fuel hose
– Create the plug-in connection
the holder.
– Attach both side covers of the lower section of the air filter box and
screw them on tightly.
– Attach the manifold pressure sensors
plug-in connections.
– Create the plug-in connection
– Put the air filter in place, position the intake trumpet
counterclockwise.
9
– Mount the intake snorkel
8
– Position the upper section of the air filter box, screw it in place and
connect the vent hose.
– Create the plug-in connection of the intake air temperature sensor
bk
– Mount the vent hose
pliers 600.29.57.100).
– Connect the negative terminal of the battery.
bk
, tighten the bolts to 10 Nm.
the
water
hoses
.
2
!
CAUTION
.
4
to the throttle body.
5
with the frame on the air filter housing.
9
.
and the hose
bl
on
the
radiator
(special
ports.
!
of the throttle body and attach it to
3
to the holder and create the
6
of the generator.
7
8
of the SLS valve (special
bm
3-42
pliers
and turn
Advertisement
Table of Contents
Troubleshooting
