KTM 990 Adventure Repair Manual page 62

3-31
1
2
– Run the tank vent hose down parallel to the overflow hose on the
compensating tank, tilt the tank forward and screw on. Connect the
tank vent hose and fuel connector.
– Mount both tank side covers and the spoiler and tighten the screws.
– Remove the assembly stand.
– Apply Loctite 243 to the screws of the footrest support
tighten to 25 Nm.
– Mount the relay lever for the shift rod, apply Loctite 243 to screw
and tighten to 18 Nm.
– Apply Loctite 243 to the screw on the shift rod
Nm.
3
– Apply Loctite 243 to the screws of the footrest support
tighten to 25 Nm.
– Apply Loctite 243 to the screw of the foot brake push rod
tighten to 12 Nm.
5
– Bleed the cooling system (see Chapter 12).
– Add engine oil (see chapter 12).
4
– Check all hose connections for leakage before taking a test ride.
– Check all hoses, lines and cables for a tight fit.
and
1
2
and tighten to 12
3
and
4
and
5