KTM 990 Adventure Repair Manual page 40

3-9
1
2
4
6
8
– Place the chain over the pinion and rear sprocket, lift the rear wheel
and slide the wheel spindle through.
– Press the rear wheel towards the front to apply the chain tensioner
1
1
– Actuate the foot brake pedal to apply the brake shoes against the
brake disk.
– Check the chain tension, see owners manual.
– Mount the chain securing guide and the chain roller.
– Insert the locking pin in the pushrod and mount the clutch slave
cylinder
3
– Position the side stand and tighten the two bolts and the nut
to 45 Nm (with Loctite 243).
– Mount the side stand switch
clips.
5
– Carefully install the oil line, mount the oil tank and tighten the
7
fixing bolts
– Connect the return line
loaded band-type clamp with the special pliers 600.29.057.100.
– Attach the oil lines from the oil tank to the valve covers
pliers 600.29.057.100).
6
– Mount both oil lines on the oil terminal
the bolts (M6x20) in the retaining brackets
NOTE:
– up to engine number 2-600-1186 a washer must be used to preload
the O-rings on the oil terminal.
– to allow the oil pump to build up the oil pressure faster, remove the
suction line (left) from the oil tank and fill with engine oil.
– Check the hose part of the suction line for cracks.
9
and tighten the nut on the wheel spindle to 90 Nm.
. Screw on the chainguard
2
5
.
6
to the oil tank and mount the spring-
7
.
3
and fasten the cable with the cable
8
with new O-rings, insert
9
and tighten to 10 Nm.
bk
bk
4
(special
bk