KTM 990 Adventure Repair Manual page 59

1
2
3
5
5
6
8
5
– Fasten the wiring harnesses and connector on the pulse generator
with cable clips.
– Run the chain over the pinion and rear sprocket, raise the rear wheel
and push the wheel spindle through.
– Push the rear wheel forward until the chain tensioner
2
against the stop screw and tighten the wheel spindle nut to 90 Nm.
– Actuate the foot brake lever until the brake pads rest against the
brake disk again.
– Check the chain tension (see Owner's Manual).
– Attach the lock pin to the pushrod and align with the recess in the
chainguard. Mount the chain clip and the chainguard.
– Mount the clutch slave cylinder
4
– Mount the oil tank and tighten the fixing screws
– Mount the suction line
7
– Connect the oil lines from the oil tank to the valve covers
pliers 600.29.057.100).
– Connect the return line
loaded band-type clamps with the special pliers 600.29.057.100.
and screw on the chainguard
3
5
with a new O-ring.
6
to the oil tank and mount the spring-
8
3-28
1
rests
2
.
4
.
(special
7