KTM 990 Adventure Repair Manual page 57

1
4
3
6
7
– Mount the exhaust pipe clamp
main silencer and slightly tighten.
– Slightly tighten the exhaust pipe clamp
NOTE:
– Do not tighten the screw connections until the exhaust system is
completely installed and mounted stress-free.
– Tighten the exhaust nuts evenly without bending the sheet.
– Tightening torque for clamp
2
– Position the side stays on the engine, insert the bolt
4
the nut.
– Turn in the screws
Tighten the nut and screws to 45 Nm.
– Tighten the nut on the swing arm bolt to 130 Nm.
– Mount the battery case with the controller and horn, using the black
screw
5
– Run the positive starter cable
on, screw on the starter ground and run to the battery case.
1
: 35 Nm and clamp
1
(M10x24), lifting the engine if necessary.
4
in the position shown.
5
6
between the manifold and the
on the rear manifold.
2
: 12 Nm.
2
and mount
3
to the starter engine and screw
7
3-26