KTM 990 Adventure Repair Manual page 69

1
2
5
7
bk
9
2
4
3
6
8
bl
– Detach the oil line between the oil tank and the valve cover from the
front of the oil tank (special pliers 600.29.57.100).
– Unscrew the oil lines from the oil terminal
remove the O-rings.
– Loosen the retaining screws
tank.
– Expose the line of the gear position sensor.
– Disconnect the plug-in connection
– Disconnect the plug-in connection
– Loosen the screws of the lateral supports and the nut
5
bolt, pull out the bolt and take off the supports.
– Unscrew the clutch slave cylinder
– Remove the chain roller and the chain securing guide.
– Pull the locking pin out of the push rod.
– Remove the adapter for the clutch slave cylinder
securing guide .
bk
– Take off the adapter for the hydraulic coupling
– Pull the locking pin out of the push rod.
and pull them out;
1
at the oil tank and take off the oil
2
of the gear position sensor.
3
of the ignition pulse generator.
4
and chainguard .
7 8
and the chain
9
.
bl
3-38
of the
6