KTM 990 Adventure Repair Manual page 48

3-17
2
1
3
4
7
6
– Unscrew the ground wire connection
1
– Detach the connector from the pulse generator
– Detach the connector from the oil pressure switch
5
– Pull the bolt
– Loosen the nut on the swing arm pivot
– Pull the engine towards the front with the trolley jack, lower and pull
– Disconnect all hoses and lines from the engine.
temperature sensor and from the front
4
Remove any cable clips necessary.
out of the lower support (if necessary, raise or lower
6
the engine slightly).
arm pivot with a suitable pipe.
away towards the side.
.
1
.
2
, the
3
and rear ignition coil.
5
and knock out the swing
7