Table of Contents
Advertisement
3-39
1
3
4
5
7
– Loosen the chain adjuster.
– Loosen the nut of the wheel spindle.
– Push the wheel into the frontmost position.
– Remove the chain
link fork.
– Take the chain off of the engine sprocket.
NOTE: To avoid damaging the link fork, place a cloth between the link
fork and the chain
– Position component 600.29.055.100 on the engine with the trolley
jack, push the bolt
raise the engine slightly.
2
– Unscrew the ground cable connections
from the starter.
3
– Disconnect the connectors of the oil pressure sensor
sensor
binders where necessary.
6
– Pull out the bolt
engine slightly if necessary).
– Loosen the nut of the swingarm pivot
swingarm pivot with a suitable pipe.
– Using the trolley jack, pull the engine forward, lower it and move it
out to one side.
– Remove all hoses and cables from the engine.
8
from the rear sprocket and place it over the
1
.
1
of the engine support through the front and
2
and the front
and rear ignition coils. Remove the cable
5
6
of the lower support (raising or lowering the
7
and the positive cable
3
, temperature
4
and hammer out the
8
Advertisement
Table of Contents
Troubleshooting
