KTM 990 Adventure Repair Manual page 134

6-21
2
1
3
5
NOTE:
– Check the position of the camshafts on cylinder front in the TDC
position of cylinder rear.
The cams on the exhaust camshaft
push open the exhaust valves, the cams on the intake camshaft
also point towards the inside, the bucket tappets are not actuated.
If the camshafts are in a different position, check the timing and
reset.
– Check valve clearance (see Chapter 12)
– Remove the crankshaft blocking tool
(M8x60) with a new sealing washer and tighten to 10 Nm.
– Screw the plug
4
Starter motor
– Insert the starter motor into the opening in the case with a new
O-ring (greased). Insert both bolts
10 Nm.
5
point towards the inside and
1
3
into the generator cover.
4
(M6x25) and tighten to
5
2
. Insert the case bolt