KTM 990 Adventure Repair Manual page 60

3-29
1
2
1
5
4
– Screw on the radiator, the fan and the radiator shield
screws to 10 Nm.
– Mount
1 600.29.057.100)
– Connect the electric connectors for the temperature switch
fan motor
1
3
– Connect the hose on the front vacuum sensor
on the front lambda probe
with a cable clip.
– A
LWAYS REPLACE THE VACUUM HOSES ON THE INTAKE MANIFOLD IF THEY WERE
PULLED OFF
– D
O NOT USE SILICONE SPRAY WHEN MOUNTING THE VACUUM HOSES
DAMAGE THE MANIFOLD AIR PRESSURE SENSORS
– D
O NOT EXCHANGE THE CONNECTIONS ON THE INTAKE MANIFOLD WITH THE
CONNECTIONS ON THE
LIKELY TO MALFUNCTION
– Place the lower air filter box on the intake ports, connect the drain
hose and push the fuel hose down through the opening in the lower
air filter box.
R
EMOVE THE CLOTH USED TO COVER THE INTAKE PORTS
– Slip the throttle body bellows over the intake manifolds.
NOTE: align the clamps on the bellows so they can be tightened
through the openings in the side cover.
– Place the throttle body in the lower air filter box and mount the
throttle cables - see throttle cable adjustment, chapter 2.
– Insert the throttle body in the bellows and tighten the bellows
clamps.
– Connect the fuel hose to the throttle body.
the water hoses on
.
3
; attach the connector to the frame
5
! CAUTION
.
950 A
DVENTURE OTHERWISE THE INJECTION SYSTEM IS
.
! CAUTION
, tighten the
1
the radiator (special pliers
2
and the connector
4
!
. I
T CAN
.
!
.
and