Table of Contents
Advertisement
1
1
2
4
3
6
7
8
– Loosen the nuts
front exhaust manifold.
– Loosen the nuts
exhaust manifold.
2
– Remove the retaining pin
– Detach the return spring of the brake lever.
– Remove the screw
– Remove the footrests on both sides.
– With the help of another person, jack up the motorcycle at the rear.
– Mount the retaining pin insert
– Raise the assembly stand at the rear and slide the retaining pins on
both sides into the footrest holder.
NOTE: If the retaining pins are difficult to slide into the footrest holder,
or cannot be slid in at all, loosen the counter nuts
retaining pins have been slid into the footrest holder, retighten them.
– Push down the rear of the assembly stand to jack up the motorcycle.
5
– Disconnect the negative terminal of the battery.
– Remove the vent hose
upper section of the air filter box (special pliers 600.29.57.100).
– Disconnect the plug-in connection
sensor.
– Unscrew the screws of the upper section of the air filter box and
remove the upper section of the air filter box.
9
of the front exhaust manifold and take off the
1
of the rear exhaust manifold and take off the rear
2
by remove the lock on the retaining pin.
3
and take off the foot brake pedal.
4
on the assembly stand.
5
and the hose
7
8
of the intake air temperature
9
3-36
and, after the
6
of the SLS valve on the
Advertisement
Table of Contents
Troubleshooting
