KTM 990 Adventure Repair Manual page 190

7-52
1
2
Roll angle sensor
The signal from the roll angle sensor
diagnostics tool.
Output signal "No crash detected": 0.4 - 1.4 volts
Output signal "Crash detected": 3.7 - 4.1 volts
In case of an error, perform the following tests:
– Ground supply (black cable) at connector AP2.
– 5-volt supply (blue cable) at connector AP2 with the ignition
switched on.
– Measure the output signal directly at connector AP2 Pin 6
(yellow/red cable).
Side stand switch
The signal for the side stand switch
diagnostics tool.
In case of an error, perform the following tests:
3
– Ground supply (black cable) connected to connector AM3
– 5-volt supply (blue cable) connector AM3 with ignition switched on.
– Measure the output signal directly at the connector AR3 Pin 3 (pink
cable).
(input)
can be scanned with the KTM
1
(input)
can be scanned with the KTM
2
Output signal up (folded up): 2-3 volts
Output signal down (folded down): 4-5 volts
.
3