KTM 990 Adventure Repair Manual page 52

3-21
1
2
3
6
7
1
1
4
5
6
7
– Screw on the radiator together with the fan and the radiator shield
, tighten the bolts to 10 Nm.
1
– Connect the water hoses
600.29.057.100)
– Attach the electric connections for the fan motor and the
temperature switch .
2
– Screw the rear exhaust manifold on to the cylinder head.
– Insert the front exhaust manifold in the rear exhaust pipe, mount to
the front cylinder head together with the sealing washer and tighten
the exhaust nuts .
3
NOTE:
– on a stud, a washer must be mounted as a spacer between the
clamping plate and the cylinder.
– the exhaust nuts should be tightened evenly without bending the
metal sheet.
– Tighten the exhaust clamps
– Attach the heat shield
5
tight.
NOTE: Lubricate the screws of the heat shield
– Route the electric lines of the lambda probes at the front and rear,
secure them with cable binders and create plug-in connections
– Attach the manifold pressure sensors
the plug-in connections.
on the radiator (special
of the front and rear manifolds.
4
on the exhaust pipe at the front and screw
with copper paste.
5
to the holders and create
7
pliers
.
6