Table of Contents
Advertisement
3-27
1
2
4
6
7
– Place the battery in the battery case and attach the battery case
cover.
– Connect the positive starter relay cable to the positive pole on the
battery.
– Connect the two ground connections to the negative pole on the
battery (2 green cables from the controller and 1 black cable from
the starter engine).
– Close the battery case cover and screw on, mount the starter relay.
– Run the wiring harness from above behind the side stay, through the
recess
1
3
– Connect connector
regulator output
connector).
– Run the horn cable
with the clip.
5
– Position the side stand and tighten both screws and the nut to
45 Nm (+ Loctite 243).
NOTE:
– Run cable
gear sensor behind the side stand console.
– Fasten the lambda probe cable to the frame with a cable clip.
– Connect the connector for the lambda probe, the side stand switch
and the gear sensor to the wiring harness.
– Align the wiring harnesses in a loop as shown in the photo and
fasten with clamp
and to the starter relay.
on the starter relay (2 red/white cables), the
2
(2 red/white cables) and the generator
3
in front of the controller, connect and fasten
5
for the lambda probe, the side stand switch and the
6
and cable clips.
7
(3-pole
4
Advertisement
Table of Contents
Troubleshooting
