Table of Contents
Advertisement
3-37
1
4
6 7
9
bm
bl
– Unscrew the screws
2
– Pull off the vent and EPC hoses and remove the top section of the
– Turn the intake trumpet
3
– Disconnect the plug-in connection
5
– Disconnect the plug-in connection
– Take the manifold pressure sensors
– Take the plug-in connection
– Pull the drain hose off of the lower section of the air filter box.
– Unscrew both side covers of the lower section of the air filter box.
7 8
– Remove the fuel line
– Fold the throttle body up toward the front and secure it on the
NOTE: The lower section of the air filter box must be raised slightly to
make room for plug-in connection of the throttle body.
– Take the lower section of the air filter box off of the intake pipe.
NOTE: The intake channels should be closed off with a cloth to keep
bk
parts from falling out.
– Disconnect the electrical plug-in connection of the horn.
– Disconnect the electrical connections of the fan motor and
– Remove the water hoses from the radiator (special pliers
– Remove the screws
NOTE: The fan and radiator shield do not need to be removed from the
radiator.
bm
and take the intake snorkel
1
off of the air filter box.
air filter box.
3
filter.
the SLS valve off of the lower section of the air filter box.
holder and disconnect the plug-in connections.
and disconnect the plug-in connection
(special pliers 600.29.57.100) and loosen
9
the hose clamps
.
bk
handlebar using a wire or rubber band; the throttle body does not
need to be removed completely.
temperature switch
.
bl
600.29.057.100)
and take off the radiator.
bm
with the frame
2
clockwise and take it off; remove the air
of the SLS valve
4
of the generator.
6
on the left and right off of the
7
of the throttle body off of the holder
8
.
8
and take
5
Advertisement
Table of Contents
Troubleshooting
