Table of Contents
Advertisement
3
2
4
7
8
9
– Place the lower section of the air filter box onto the intake flange.
R
EMOVE THE CLOTH USED TO COVER THE INTAKE PORTS
– Place the throttle body into the lower section of the air filter box.
NOTE: The lower section of the air filter box must be raised slightly to
make room for the plug-in connection
– Connect the drain hose to the lower section of the air filter box.
1
– Connect the lower section of the air filter box to the intake flange.
– Attach the sleeves of the throttle body to the intake flange.
NOTE: the clamps on the carburetor connection boots must be aligned
so that they can be tightened through the openings in the side covers.
– Insert the throttle body into the sleeves and tighten the hose clamps
2
– Connect the fuel hose
– Create the plug-in connection
– Mount the SLS valve
create the plug-in connection.
– Mount the air filter, position the intake trumpet
counter-clockwise direction.
6
– Mount the intake snorkel
– Screw on the upper air filter box half. Connect the vent hose and the
EPC hose.
5
– Fit the upper battery cover and place a battery with battery cover
into the battery compartment.
– Fit the front battery compartment lid and connect both battery
cables
positive cable).
– Close the front battery compartment lid.
7
– Mount the underride protection, apply Loctite 243 to the 4 bolts
(M8x14 collar bolts) and tighten to 25 Nm.
– Mount the front cover, apply Loctite 243 to both bolts
and tighten to 25 Nm.
9
!
CAUTION
of the sleeves.
to the throttle body.
3
1
on the lower section of the air filter box and
4
with the frame to the filter housing.
6
together to the connections on the front lid (start with the
7
!
.
of the throttle body
1
of the throttle body.
and turn in a
5
(M8x16)
9
3-22
8
Advertisement
Table of Contents
Troubleshooting
