KTM 990 Adventure Repair Manual page 64

3-33
2
3
4
– Expose the lines of the ignition coil connectors for the cylinder at
the front and rear, take the plug-in connections off of the holder and
disconnect the plug-in connections
and rear.
1
– Unscrew the holder
engine.
– Loosen the exhaust clamps
manifold.
3
– Unscrew both nuts
cylinder head.
– Pull the front exhaust manifold out of the rear exhaust pipe and
remove it.
– Unscrew both nuts
head and remove them.
NOTE:
– on a stud, a sleeve must be mounted as a spacer between the
5
cylinder and the clamping plate.
– the nuts
exhaust manifold must be tightened evenly without warping the
clamping plate.
– Assembly is performed in reverse order.
of the front exhaust manifold from the
2
of the front and rear exhaust
3
of the front exhaust manifold flange from the
4
of the rear exhaust manifold from the cylinder
5
of the front exhaust manifold and the nuts
4
for the cylinder at the front
1
of the rear
5