KTM 990 Adventure Repair Manual page 37

1
3
4
6
7
bk
9
– Use the trolley jack to position the attachment 600.29.055.100 on
2
– Remove the bolt
– Unscrew the ground wire connection
– Detach the connector from the pulse generator
5
– Detach the connector from the oil pressure switch
8
– Pull the bolt
– Loosen the nut on the swing arm pivot
– Pull the engine towards the front with the trolley jack, lower and pull
– Disconnect all hoses and lines from the engine.
the engine, insert the bolt
1
and fasten with the nut. Screw one of the bolts
side stand fixture and slightly lift the engine.
and tilt the foot brake pedal to the side.
3
temperature sensor and from the front
7
Remove any cable clips necessary.
out of the lower support (if necessary, raise or lower
9
the engine slightly).
arm pivot with a suitable pipe.
away towards the side.
through the front of the engine bracket
on the rear of the
2
.
4
.
5
and rear ignition coil.
8
and knock out the swing
bk
3-6
, the
6