KTM 990 Adventure Repair Manual page 72

3-41
1
4
7
8
9
2
3
5
6
8
bl
bk
– Insert the locking pin in the pushrod.
– Mount the adapter for the hydraulic clutch
– Mount the chain securing guide
slave cylinder .
3
– Screw on the clutch slave cylinder
– Align the side supports and battery case against the engine, insert
the bolt and mount the nut.
6
– Mount the bolts (M10x23), lifting the engine slightly if necessary.
7
Tighten the nut and bolts to 45 Nm.
– Tighten the nut on the swing arm pivot to 130 Nm.
– Carefully install the oil line, mount the oil tank and tighten the
fixing bolts .
8
– Connect the return line to the oil tank and mount the spring-loaded
band-type clamp with the special pliers 600.29.057.100.
– Mount both oil lines on the oil terminal
in the screws (M6x20) with the holding plates and tighten with 10
Nm.
NOTE:
– To ensure that the oil pump can build up oil pressure more quickly,
the intake line (left) should be removed from the oil tank and
prefilled with engine oil.
– Check the hose section of the intake line for tearing - see Technical
Information.
– Create the plug-in connection
secure the line with cable binders.
– Create the plug-in connection of the ignition pulse generator
.
1
and the adapter for the clutch
2
and the chainguard
4 5
with new O-rings, screw
9
of the gear position sensor and
bk
.
.
bl