Dynamic Host Configuration Protocol (Dhcp); General Information (Dhcp) - Agilent Technologies 1260 Infinity II User Manual

Dynamic Host Configuration Protocol (DHCP)

General Information (DHCP)

The Dynamic Host Configuration Protocol (DHCP) is an auto configuration
protocol used on IP networks. The DHCP functionality is available on all
Agilent HPLC modules with on-board LAN Interface or LAN Interface Card
G1369C, and "B"-firmware (B.06.40 or above) or modules with "D"-firmware.
All modules should use latest firmware from the same set.
When the initialization mode "DHCP" is selected, the card tries to download
the parameters from a DHCP Server. The parameters obtained become the
active parameters immediately. They are not stored to the non-volatile
memory of the card.
Besides requesting the network parameters, the card also submits its
hostname to the DHCP Server. The hostname equals the MAC address of the
card, e.g. 0030d3177321. It is the DHCP server's responsibility to forward the
hostname/address information to the Domain Name Server. The card does not
offer any services for hostname resolution (e.g. NetBIOS).
Figure 28
1 It may take some time until the DHCP server has updated the DNS server with the
N O T E
2 It may be necessary to fully qualify the hostname with the DNS suffix, e.g.
3 The DHCP server may reject the hostname proposed by the card and assign a name
InfinityLab LC Series 1260 Infinity II Binary Pump User Manual
DHCP (Principle)
hostname information.
0030d3177321.country.company.com.
following local naming conventions.

Dynamic Host Configuration Protocol (DHCP)

12
LAN Configuration
209