Offline Debugging Of The Sensor Control Program And Sensor Opera; Tion; Operation - Omron ZW-7000 Series User Manual

6-4 Offline Debugging of the Sensor Control Program and Sensor Operation
If an EtherCAT system is configured, you can perform a linked simulation between the sequence control of an
NX/NJ-series Controller and the operation of an ZW Sensor.
The sensor control program can be debugged offline using measurement results saved by the data trace
function.
Sysmac Studio
Computer
Note
Sensor measurement and other operation cannot be simulated. The measurement result acquired previously by the
data trace function is output.
Important
Simulation is possible only on the Standard Edition of the Sysmac Studio.
Registering the ZW as an EtherCAT Slave
You use the Sysmac Studio (Standard Edition) to add the ZW to the EtherCAT slave configuration.
Refer to the Sysmac Studio Version 1 Operation Manual (Cat. No. W504) for details on registering slaves.
Only simplified procedures are provided here.
• Opening the Edit EtherCAT Configuration Tab Page
 Multi view Explore
• Registering a Slave Offline (Building the Network Configuration)
1
Use either of the following methods to add an ZW slave to the master.
• Drag [ZW-C7000
drop or double-click.
186
Offline Debugging of the Sensor Control Program and Sensor Operation
NJ-series Controller Simulator (virtual Controller)
Sysmac
Studio
Simulator
connection
(1) TIMING input and control
EtherCAT online connection
(3) Outputting measurement results to the
Operations That Are Possible with Simulation
: [Configurations and Setup] | [EtherCAT] (Double-click)
□
] from the [Toolbox] to the master in the Edit Network Configuration Tab Page, and then
User
program
command
storage area in the NJ-series Controller
ZW Sensor Simulator
Measurement result file
saved by data trace function
(2) Acquisition of measured value
from file
ZW-7000/5000
User's Manual