Setting the Offset
Setting the Offset p.153
As an example, here is an explanation of the procedure for selecting the "10 mm" reference value setting.
Operating procedure
Steps
Key operation
1 to 5
For moving to "ZERO", see steps 1 to 5 in p.230.
6
7
8
9
ZW-7000/5000
User's Manual
Display
Description
Press the
key.
Change the offset value.
The current setting value is displayed on the sub-display.
Press
blinks.
To edit numerical values, use the
In this example, input "10", then press the
The decimal point is displayed.
Press the
Determine the decimal point and then press the
Press the
/
keys to select "OFFSET" and press the
key to enter the editing mode, and the sub-display
/
/
/
key to move the decimal point.
key for two seconds to enter the RUN mode.
Setting the Output Conditions
/
keys.
key.
key.
231