Omron ZW-7000 Series User Manual page 72

Class Name
Parallel HIGH output
output
PASS output
LOW output
ALARM output
BUSY output
ENABLE output
BANK_OUT output
SYNCFLG/TRIGBUSY
output
STABILITY output
LOGSTAT output
LOGERR output
TASKSTAT output
In FUNC mode, output of each signals are the followings;
• BUSY output Turns ON
• BANK_OUT Outputs the current bank number
• Other signals Turns OFF
70
Wiring
Description
This outputs judgment results - HIGH (HIGH threshold values < Measured value).
This outputs judgment results - PASS (LOW threshold values ≤ Measured value ≤ HIGH
threshold values).
This outputs judgment results - LOW (LOW threshold values > Measured value).
This turns ON when there is a system error.
This turns ON during sampling with the hold function enabled. It allows you to check
whether or not the self-trigger is functioning correctly.
It also turns ON during bank switching.
This turns ON when the sensor is ready for measurement.
This output is interlocked with the ENABLE indicator.
This outputs the currently specified bank number.
It expresses the bank number in combinations of BANK_OUT1, 2 and 3.
Bank Number BANK_OUT1
BANK1 OFF
BANK2 ON
BANK3 OFF
BANK4 ON
BANK5 OFF
BANK6 ON
BANK7 OFF
BANK8 ON
In the internal/PDO synchronized mode, this output operates as SYNCFLG. This turns ON
when measurement synchronization processing is executed by SYNC input and the state
changes to one where normal measurement values can be output.
In the external synchronous measurement mode, this output operates as TRIGBUSY. This
turns ON while a measurement by TRIG input is being performed. The next TRIG input
cannot be turned ON until this turns OFF.
This turns ON when 1surface is within the measurement range.
This output is interlocked with the STABILITY indicator.
This turns ON while internal logging is in execution.
This turns ON when internal logging fails. Turns ON when the logging results is saved the
maximum number, retry to execute the inside logging. If the LOGGING signal turns OFF,
LOGERR signal is also turned OFF.
This turns ON when the measurement value is finalized.
BANK_OUT2 BANK_OUT3
OFF OFF
OFF OFF
ON OFF
ON OFF
OFF ON
OFF ON
ON ON
ON ON
ZW-7000/5000
User's Manual