Performance Specifications; Hydraulic Oil Specifications - Genie S-80 Service Manual

Service Manual
Specifications

Performance Specifications

Drive speed, maximum
Stowed position,
RT tires
Stowed position,
High Flotation tires
Raised or Extended
Braking distance, maximum
High range on paved surface
Gradeability
Boom function speeds, maximum from platform
controls
Jib Boom up (S-85)
Jib Boom down (S-85)
Boom up (ANSI, CSA, models)
Boom up (CE, AS models)
Boom down (ANSI, CSA, models)
Boom down (CE, AS models)
Boom extend
Boom retract
Turntable rotate, (360°) fully stowed
Turntable rotate, (360°) boom raised
or extended
Platform rotate, 160°
Platform level (10° range of motion)
ANSI, CSA
Platform level (10° range of motion)
CE, AS
For operational specifications, refer to the
Operator's Manual.
2
40 ft / 7.9 - 8.5 sec
12.2 m / 7.9 - 8.5 sec
40 ft / 11 - 13 sec
12.2 m / 11 - 13 sec
40 ft / 40 - 45 sec
12.2 m / 40 - 45 sec
6 ft / 1.8 m
Refer to Operator's Manual
25 - 35 sec
15 - 25 sec
57 - 65 sec
75 - 83 sec
61 - 69 sec
75 - 83 sec
59 - 67 sec
57 - 65 sec
95 - 103 sec
210 - 250 sec
8 - 12 sec
3 - 5 sec
20 - 22 sec
S-80 • S-85 • S-80X

Hydraulic Oil Specifications

Hydraulic Fluid Specifications
Genie specifications require hydraulic oils which are
designed to give maximum protection to hydraulic
systems, have the ability to perform over a wide
temperature range, and the viscosity index should
exceed 140. They should provide excellent antiwear,
oxidation prevention, corrosion inhibition, seal
conditioning, and foam and aeration suppression
properties.
Cleanliness level,
minimum
Water content,
maximum
Recommended Hydraulic Fluid
Hydraulic oil type
Viscosity grade
Viscosity index
Optional Hydraulic Fluids
Mineral based
Biodegradable
Fire resistant
Note: Genie specifications require additional
equipment and special installation instructions for
the approved optional fluids. Consult Genie
Product Support before use.
Optional fluids may not have
the same hydraulic lifespan and
may result in component
damage.
Note: Extended machine operation can cause the
hydraulic fluid temperature to increase beyond it's
maximum allowable range. If the hydraulic fluid
temperature consistently exceeds 200°F / 90°C an
optional oil cooler may be required.
February 2017
ISO 15/13
250 ppm
Chevron Rando HD Premium
Shell Tellus S2 V 32
Shell Tellus S2 V 46
Shell Tellus S4 VX 32 Shell
Shell Donax TG (Dexron III)
Chevron 5606A
Petro Canada Environ MV 46
UCON Hydrolube HP-5046
Part No. 1259369GT
32
200