Jib Boom Components; Jib Boom - Genie S-65 XC Service And Repair Manual

Service and Repair Manual

Jib Boom Components

3-1

Jib Boom

How to Remove the Jib Boom
Note: Perform this procedure with the boom in the
stowed position.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications, Hydraulic Hose and Fitting Torque
Specifications.
1 Remove the platform.
2 Remove the platform mounting weldment.
3 Remove the hose and cable cover from the
side of the jib boom.
4 Remove the hose and cable clamp from the jib
boom pivot pin. Lay all hoses and cables to the
side.
Component damage hazard.
Hoses and cables can be
damaged if they are kinked or
pinched.
5 Tag, disconnect and plug the jib boom lift
cylinder hydraulic hoses. Cap the fittings on
the cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
42
6 Attach a lifting strap from an overhead crane to
the jib boom assembly.
7 Place blocks under the platform leveling
cylinder for support. Protect the cylinder rod
from damage.
8 Remove the pin retaining fastener from the
slave cylinder rod-end pivot pin. Use a soft
metal drift to remove the pin.
9 Remove the pin retaining fastener from the jib
boom bellcrank to primary boom pivot pin.
10 Use a soft metal drift to remove the pin and
carefully remove the jib boom assembly from
the primary boom.
® ™ ® ™
S -60 XC • S -65 XC
September 2018
Crushing hazard. The jib boom
could fall when the slave cylinder
rod-end pivot pin is removed if
not properly attached to the
overhead crane.
Crushing hazard. The jib boom
may become unbalanced and fall
when it is removed from the
machine if it is not properly
supported by the overhead
crane.
Part No. 1288652GT