Oxi Max Sensor Event Record Data Available - Nellcor OxiMax N-595 Operator's Manual

O M Sensor Event Record Data Available
XI AX
TREND
SENSOR
N-595
displayed after the O
XI
identifies the monitor's current data type setting that will be used to
write data to the O M
XI
EVENT/SPO and EVENT/SPO
2
The user can change the setting by referring to Setting In-Sensor Data
Type on page 66. The O
prior to connecting the O
When an O M sensor containing data (single-patient-use O
XI AX
sensors only) is connected to the monitor, the Sensor Event Record
indicator on the monitor front panel blinks at a medium priority flash
rate to indicate that the O
contains patient event data. The LED blinks for approximately 60
seconds or until the O
trend data is displayed by pressing TREND, then SENSOR.
A corresponding "DATA IN SENSOR" message is also displayed at
the bottom of the display. After 4 to 6 seconds, if all the data has been
read from the O M
XI AX
menu.
OXIMAX Sensor Event Record
M sensor type message. The message
AX
sensor. The data type setting options are
AX
+BPM.
2
M sensor event record type must be set
XI AX
M sensor to the monitor.
XI AX
M sensor attached to the monitor
XI AX
M sensor is disconnected or until the sensor
XI AX
sensor, the message is replaced with the main
M
XI AX
69