Oxi Max Sensor Messages - Nellcor OxiMax N-595 Operator's Manual

LANG
EXIT
O M Sensor Messages
XI AX
N-595
3. Press the LANG softkey.
4. Use the ADJUST UP or ADJUST DOWN buttons to select the
desired language.
5. Press the EXIT softkey.
Note: The selected language will be displayed until the monitor is
turned off. The selected language can be set as a default by
qualified service personnel following the procedures in the
service manual.
O M sensor messages consist of sensor adjust condition messages
XI AX
and sensor adjust messages which, when enabled, are displayed when
the monitor is not able to display saturation. When O
messages are displayed, it is an indication that the O
functioning correctly, but the site to which the O
or the application method is not optimal for calculating %SpO
Condition messages are followed by action messages. Up to three
condition messages may be displayed on the "POOR SIGNAL
CONDITION" display in priority order, highest on top. The condition
display may be dismissed by using the EXIT softkey. Once exited, the
Using the Monitor
M sensor
XI AX
M sensor is
XI AX
M sensor applies
XI AX
.
2
49