Setting The Date And Time - Nellcor OxiMax N-595 Operator's Manual

Setting the Date and Time

SETUP
N-595
1. Press the ALARM SILENCE button until the alarm volume level
is displayed and sounds on the monitor.
2. While continuing to press the ALARM SILENCE button, press
and hold the ADJUST UP/ADJUST DOWN button to increase/
decrease the volume.
WARNING: The sensor extrapolates from the date and time
provided by the N-595 when recording the sensor event record to
the sensor. The accuracy of the date/time is the responsibility of
the N-595. It is recommended that the N-595 user set the time/
date to the correct value before a sensor event record-enabled
sensor is connected, and that this date/time not be changed while
the sensor remains connected. Since a sensor with sensor event
record data can be transported from one monitor to another,
having discrepancies in the date/time between monitors and the
sensor event record data will affect the order the sensor event
record data appears. To eliminate this possible problem, all
monitors within an institution should be set to the same time.
With the monitor in the normal monitoring mode:
1. Press the SETUP softkey.
Using the Monitor
37