Description Of Audible Indicators; Table 1: Audible Indicators - Nellcor OxiMax N-595 Operator's Manual

Description of Controls, Indicators, and Symbols

Description of Audible Indicators

14
Table 1 identifies the audible indicators of the N-595 indicators.

Table 1: Audible Indicators

Function
Alarm Silence
Reminder
Confirmation Tone
Invalid Button Press
Valid Button Press
High Priority Alarm
Medium Priority
Alarm
Low Priority Alarm
- -
Power On Self Test
Pass
Pulse Beep
Volume Setting Tone
Description
Three beeps that sound approximately every 3
minutes when alarms are silenced with the
alarm silence duration set to Off and the alarm
silence reminder function is enabled.
Three beeps sound to indicate that default
settings have been saved or reset to factory
defaults or trend data has been deleted.
-
A short, low pitched tone indicating that a
button has been pressed that is not appropriate
for the current state of the monitor.
-
A short, medium pitched tone indicating that
an appropriate button has been pressed.
- -
A high pitched, fast pulsing tone indicating
- -
loss of pulse.
-
A medium pitched, pulsing tone indicating an
SpO or pulse rate limit violation.
2
- -
A low pitched, slow pulsing tone indicating an
O M
sensor disconnect, low battery, or
XI AX
monitor failure.
-
A 1 second tone indicating that the N
been turned on and has successfully completed
- -
the power on self test.
A single beep sounds for each detected pulse.
The pitch of the pulse beep signal changes with
- -
a point by point rise or fall in the saturation
level.
A continuous tone that is used when adjusting
the alarm volume.
-
595 has