Setting Satseconds Alarm Limit - Nellcor OxiMax N-595 Operator's Manual

Using the Monitor

Setting SatSeconds Alarm Limit

LIMITS
SELECT
EXIT
46
Note: Limit changes will only be in effect as long as the monitor
remains turned on. When the monitor is turned off, the
institutional or factory default limits will be restored into the
monitor. When the monitor is turned on, the institutional or
factory default limits will be in effect. Factory or institutional
defaults are selected by qualified service personnel following
the procedure in the service manual.
Refer to Describing SatSeconds on page 135, for a description of the
SatSeconds function.
With the monitor in the normal monitoring mode:
1. Press the LIMITS softkey. Current alarm limits are displayed.
2. Press the SELECT softkey twice to select %SpO
3. Use the AJDUST UP or ADJUST DOWN buttons to select the
limit. The choices are 10, 25, 50, or 100 seconds or OFF.
4. Press the EXIT softkey to save your choice.
SAT-S.
2