Appendix 4.3 Parameters - Mitsubishi Q2ACPU User Manual

APPENDICES
Appendix 4.3 Parameters
The following parameter settings only are converted to QnACPU use.
• Latch range setting
• MELSECNET (II, /10) setting
• I/O assignment
• MELSECNET/MINI auto refresh setting
The following items are set for the QnACPU default.If settings have been made, make the
settings again.
• RUN-PAUSE contacts
• Output at STOP
• Interrupt counter No.
• WDT setting
• Operation mode when
Converted to the "latch clear key valid" range.
The latch clear key invalid range is made blank (no setting).
For the MELSECNET setting when the ACPU is an AnN or AnA, the number of
modules are stored after conversion, but the network refresh parameters are not
converted.
Only the head I/O No. is made blank; all other items are converted.
If only I/O assignment was set in the parameters and MELSECNET/MINI auto refresh
settings have not been made, the MELSECNET/MINI data link operates with the
default values.
RUN
there is an error
: No setting
: Before operation
: No setting
: 200ms
: STOP (All items)
App - 120