Mitsubishi Q2ACPU User Manual page 532

APPENDICES
Error Code
Error
(Hexadecimal)
4040
H
4041
H
4042
H
Special
function
module
4043
H
designation
error
4044
H
4045
H
4046
H
4050
H
4051
H
4052 Protect error
H
4053
H
4054
H
Error Contents
The designated special function
module cannot perform the
request contents.
Access range exceeds the buffer
memory range of the designated
special function module.
Access to the designated special
function module is not possible.
The special function module is not
at the designated position.
A control bus error has occurred.
Setting required for simulation has
not been made.
The head number of the device or
the number of device points
designated for simulation is not in
16-point units.
Request contents cannot be
performed because the write
protect switch of the memory card
is ON.
The designated device memory
cannot be accessed.
Data cannot be written to the
designated file because its
attribute is read only.
An error occurred when writing
data to the designated drive
memory.
An error occurred when deleting
data from the designated drive
memory.
Message Displayed
at Peripheral Device
The unit does not exist.
The # of devices is too large.
The corresponding unit is
faulty.
The unit does not exist.
The corresponding unit is
faulty.
Data error
Device No. is not in 16 units.
Cannot execute as the
memory protect switch is ON.
Wrong ROM
Write is prohibited.
Cannot write correctly in
ROM.
Cannot erase ROM correctly.
App - 135
Corrective Action
Do not make requests which
caused an error to the designated
special function module.
Check the head address and
number of accessed points, and
access within the actual ranges at
the special function module.
Check if the designated special
function module normally
operates.
Check the head I/O No. of the
designated special function
module.
Check if there is a fault in the
hardware of the special function
module or other modules.
Make settings for the simulation.
Check the head number and
number of device points and then
modify them to 16-point units.
Turn the write protect switch of the
memory card OFF.
Check the following and take
corrective action.
• Whether the memory is usable
• Whether the designated drive
memory correctly installed
Do not write data to the
designated file.
Or change the file attribute.
Check the designated drive
memory.
Or replace the target drive
memory and then rewrite the data.
Check the designated drive
memory.
Or replace the target drive
memory and then delete the data
again.